FEC Handheld Nutrunner HFC3000, Инструкция по эксплуатации

Страница: 184 / 231

Chapter 9 Fieldbus I/O Interfaces
PAGE 9-4
②
OUTPUT signal format
[HFC3000→PLC]
The output signal is a fixed layout.
Word Byte
Singnal Name Connection Contents
No. Bit# No. Bit#
OUT
No.01
0
OUT
No.01
0 END NO Outputs when fastening operation ends.
1 1 ACCEPT NO Outputs when fastening result falls within set limits
2 2 REJECT NO Outputs when fastening result is outside of set limits.
3 3 MANREV NO
Outputs when a manual reverse is active
Is off if RESET or PROGRAM is input
4 4 BANK OUTPUT NO Outputs if fieldbus message bank reshuffling BIT input is on
5 5 BATCH OK NO Outputs when Batch fastening is completed within set limits
6 6
Fastening Result
Data Available
NO Outputs when fastening ends and data is available
7 7 CF ERROR NO
With the CF option installed, Outputs when the following
conditions are true
· CF card not inserted
· CF card remaining capacity is 1% or less (~ V1.209)
· CF card remaining capacity is less than 20MB (V1.210 ~)
8
OUT
No.02
0
Work OUTPUT Bit4
NO
Outputs when corresponding Work Select 4~5 inputs ON
9 1 Work OUTPUT Bit5 NO
10 2 1ST Time Reject NO
Outputs when fastening is outside of 1ST Time High and Low
limits
11 3 2ND Time Reject NO
Outputs when fastening is outside of 2ND time High and Low
limits.
12 4 Work OUTPUT Bit0 NO
Outputs when corresponding Work Select 0~3 inputs ON
13 5 Work OUTPUT Bit1 NO
14 6 Work OUTPUT Bit2 NO
15 7
Work OUTPUT Bit3
NO
OUT
No.02
0
OUT
No.03
0
REJECT
NO Outputs when fastening result is outside of set limits.
1 1 ACCEPT NO Outputs when fastening result falls within set limits
2 2 ABNORMAL NO Outputs when a system abnormal occurs.
3 3
READY
NO Outputs when system is ready to run
4 4
BUSY NO
Outputs during fastening or reverse operation
5 5
TQ HI REJECT
NO
Outputs when fastening torque is outside the Peak, Final, and
Sung torque High limits.
SNUG HI REJECT
6 6
TQ LO REJECT NO
Outputs when the fastening torque is outside the Peak, and
Final torque Low limits.
7 7
PROGRAM
OUTPUT
NO
Output echo of PROGRAM input
8
OUT
No.04
0
ANG HI REJECT
NO
Outputs when the fastening angle is outside the Final and
DIFF angle High limits.
DIFF HI REJECT
9 1
ANG LO REJECT
NO
Outputs when the fastening angle is outside the Final and
DIFF angle Low limits.
DIFF LOW REJECT
10 2
RATE1 HI REJECT
NO
Outputs when the fastening rate is outside the Rate1 High
limits.
11 3 RATE 1 LO REJECT NO
Outputs when the fastening rate is outside the Rate1 Low
limits.
12 4
RATE 2 HI REJECT NO
Outputs when the fastening rate is outside the Rate2 High
limits.
13 5
RATE 2 LO REJECT NO
Outputs when the fastening rate is outside the Rate2 Low
limits.
14 6
RATE 3 HI REJECT
NO
Outputs when the fastening rate is outside the Rate3 High
limits.
15 7 RATE 3 LO REJECT NO
Outputs when the fastening rate is outside the Rate3 Low
limits.
(Continued on next page)