FEC Handheld Nutrunner HFC3000, Инструкция по эксплуатации

Страница: 60 / 231

Chapter 4 Installation and Wiring
PAGE 4-24
When the fastening judgment is NG (REJECT)
1 2 3 4 5 6 7 8 9 10 11 12 13 14
COUNT No. ACCEPT
COUNT
AXIS No.
WORK No.
30H 30H 30H 31H 39H 39H 30H 31H 20H 20H 30H 31H 20H 20H
0 0 0 1 9 9 0 1 0 1
15 16 17 18 19 20 21 22 23 24 25 26 27 28
PEAK TORQUE JDG
OCR
FINAL ANGLE JDG
OCR
20H 31H 2EH 32H 33H 4CH 20H 20H 20H 20H 35H 30H 4CH 20H
1 . 2 3 L 5 0 L
29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44
FINAL TORQUE JDG OCR SIGN RATE1 JDG OCR SIGN
20H 31H 2EH 32H 33H 4CH 20H 20H 30H 2EH 31H 32H 33H 20H 20H 20H
1 . 2 3 L 0 . 1 2 3
45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60
RATE2 JDG OCR
SIGN
RATE3 JDG OCR
30H 2EH 31H 32H 33H 20H 20H 20H 31H 2EH 31H 32H 33H 48H 58H 20H
0 . 1 2 3 1 . 1 2 3 H X
61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76
1ST TIME JDG
OCR
2ND TIME JDG
OCR
20H 31H 30H 2EH 30H 20H 20H 20H 20H 20H 32H 2EH 30H 20H 20H 20H
1 0 . 0 2 . 0
77 78 79
JDG CR LF
58H 0DH 0AH
X
1
st
CAUSE OF REJECT (OCR)
“X” (58H):This is set for the initial cause of
the REJECT condition during this cycle
(JDG: Judgment, OCR: Occurrence)
[PEAK TORQUE] JUDGMENT
"H"(48H): HIGH REJECT
"L"(4CH): LOW REJECT
"A"(41H): ABNORMAL "S"(53H): STOP
"B"(42H): BYPASS
“R”(52H): RESET
“D” (44H): START OFF (Start trigger was released during fastening)
The OCR will identify the cause of the initial reject item and is not set in the
case of Judgments of "A," "B," "
S," “R,” or “D.” above (see REJECT fastening
judgment output data example)
[FINAL TORQUE], [ANGLE], [RATE], [TIME] JUDGMENT
"H"(48H): HIGH REJECT
"L"(4CH): LOW REJECT
TOTAL JUDGMENT
"X"(58H): Fastening
judgment REJECT