Fagor CNC 8060, Руководство по установке

Страница: 461 / 698

Installation manual.
CNC 8060
CNC 8065
TOOL
A
ND MA
GAZIN
E
MANAGEMEN
T.
7.
Too
l load
ing an
d unlo
adi
ng fro
m
the maga
zi
nes.
·461·
(R
EF
: 1709)
7.5 Tool loading and unloading from the magazines.
Tool loading and unloading from the magazine.
Each magazine table has softkeys for initializing, loading and unloading tools in the
magazine either manually or automatically. Refer to the operating manual.
The tools may also be loaded and unloaded in the magazine by program or in MDI mode.
Tool loading and unloading from the spindle.
The tools must always be loaded and unloaded in the spindle and on the changer arm in
manual mode from the magazine table. Refer to the operating manual.
Loading the magazine by program or in MDI mode.
The tools are loaded in the magazine by taking them one by one from ground to the magazine
going through the spindle.
Set the variable: V.TM.MZMODE=1 to "tell" the tool manager that the magazine loading
mode has be chosen.
If a T1 M6 is executed next, the tool manager interprets that T1 must be taken from ground
to the magazine going through the spindle and it will let the PLC know by setting
TMOPERATION=9.
The subroutine associated with the M06 function and the PLC program must contain the
maneuver needed to make the tool change.
After loading the tool, the tool manager updates the magazine table.
Unloading the magazine by program or MDI.
The tools are unloaded from the magazine taking them one by one from the magazine to
the ground going through the spindle.
Set variable: V.TM.MZMODE=2 to "tell" the tool manager that the magazine unloading mode
has been chosen.
If a T1 M6 is executed next, the tool manager interprets that T1 must be taken from magazine
to the ground going through the spindle and it will let the PLC know by setting
TMOPERATION=10.
The subroutine associated with the M06 function and the PLC program must contain the
maneuver needed to make the tool change.
After unloading the tool, the tool manager updates the magazine table.
Placing a tool in the spindle by program or in MDI mode
Set variable: V.TM.MZMODE=0 to "tell" the tool manager that the normal mode has been
chosen.
If T1 M6 is executed next, the tool manager checks whether there is already a tool in the
spindle (to remove it first) and whether the requested tool is in the magazine or it has to be
picked up from the ground. In any case, it lets the PLC know which operation it must carry
out by setting TMOPERATION to the proper value.
The subroutine associated with the M06 function and the PLC program must contain the
maneuver needed to make the tool change.
After placing the tool, the tool manager updates the magazine table.