Fagor CNC 8060, Руководство по установке

Страница: 54 / 698

Installation manual.
CNC 8060
CNC 8065
1.
SOFTWARE INSTALLATION.
Insta
llatio
n
of
third
-p
a
rty software (CNC 806
5 only).
·54·
(R
EF
: 1709)
1.5 Installation of third-party software (CNC 8065 only).
The CNC you have purchased is an industrial PC equipped with Windows XP Embedded
or Windows 7 operating system that permits the installation of third-party applications. The
installation of this software must meet the following requirements.
Any malfunction of the equipment due to the installation of third-party software frees Fagor
Automation from any responsibility.
Installation in the hard disk.
The CNC that you purchased may have either just a compact flash or a compact flash and
a hard disk. To install any software, the CNC must have enough free memory in the compact
flash. To avoid ending up with little free memory in the compact flash, it may be necessary
to install third-party software in a hard disk.
Also, in order to install third-party software, you must have an open system; i.e. with access
to the administrator. The access to the administrator mode is enabled with the validation
code. If you don't have this software option, you will not be able to access the administrator
mode and, therefore, you will not be able to install third-party software. Software installation
done in setup mode or user mode will disappear when turning the CNC off.
The access to the administrator mode is protected with the password "administrator mode",
defined in the utilities mode. To obtain the relevant password, contact the supplier of your
machine.
When installing third-party software, remember that the results of the software, generated
programs, etc. must be saved in an unprotected folder, for example CNC8070\USERS.
Never use a protected foder because it will be temporary and it will disappear when turning
the CNC off.
System requirements.
Before installing the software, make sure that the CNC meets all the requirements of the
software, both the CPU and the memory. You can consult this information in the CNC's
diagnosis mode.
Also check that there is enough free memory space in the disk for your application.
Remember that the equipment, the operating system and the CNC (depending on the
configuration of the machine) may consume between 50% and 60% of the available
resources. Once the software has been installed, the CNC being up and running, check the
status of the system resources and check that the CNC is running properly, screen refresh,
etc.