Fagor CNC 8060, Руководство по установке

Страница: 97 / 698

Installation manual.
CNC 8060
CNC 8065
MACHINE PA
RAMETERS.
2.
Gen
e
ral machin
e parameters.
·97·
(R
EF
: 1709)
BLOCK
Number of the logic block.
Possible values: From 1 to 64.
Default value: 0.
Associated variable: (V.)MPG.DIMODBLOCK[nb]
Number of the logic block. The maximum number of logic blocks in the system will be 64,
both for digital inputs and digital outputs.
ADDRESS
Base address of the logic block.
Possible values: From 1 to 1017.
Default value: The first valid value.
Associated variable: (V.)MPG.DIMODADDR[nb]
This parameter sets the base index from which the digital inputs of the logic block are
numbered. The values of the base index must be comply with the formula "8n + 1" (i.e. 1,
9, 17, 25, etc.). If an invalid base index is entered, it assumes the nearest previous valid one.
The base indexes may follow any order, they do not have to be sequential.
In the RIO5 nodes, each double module (module with two boards) it counts as two, in other
words, two logic blocks. These modules must be assigned two base indexes for the inputs
and two base indexes for the outputs; one for each board.
NDI
Number of digital inputs of the logic block.
Possible values: From 8 to 1024.
Default value: 0.
Associated variable: (V.)MPG.DIMODNDI[nb]
Number of digital inputs of the logic block; it must be other than zero and a multiple of 8 (8,
16, 24, 32, ...1024). The parameters of all the resources of a node must be set; no I/O can
be left without a number.