Fagor CNC 8060, Руководство по установке, Страница: 513 / 698

Installation manual.
CNC 8060
CNC 8065
TOOL
A
ND MA
GAZIN
E
MANAGEMEN
T.
7.
Asyn
ch
rono
us mag
a
zine
w
ith
ch
ange
r arm.
·513·
(R
EF
: 1709)
TMOPERATION = 9
Take a ground tool to the magazine going through the spindle.
The sequence of this operation is the following.
1 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
2 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
3 Start sending the changer arm to the magazine to leave the tool in holder 2.
4 When the arm leaves the collision zone, activate TCHANGEOK, if so desired, to continue
executing the program.
5 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
TMOPERATION = 10
Take a tool from the magazine and leave on the ground going through the spindle.
The sequence of this operation is the following.
1 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
2 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
TMOPERATION = 11
Take a tool from the magazine and insert it in the arm.
This operation is an optimization of the tool change that permits placing a tool in claw ·1·
of the tool changer arm while machining. This operation may be used in the following cases.
First case. When executing a T function while machining.
1 Take the tool from the magazine with holder 1 and activate the mark MZTOCH1.
Second case. When requesting a new tool and there is another one in holder 1 of the arm.
1 Leave the tool of holder 1 in the magazine and activate the mark CH1TOMZ.
2 Take the tool from the magazine with holder 1 and activate the mark MZTOCH1.
TMOPERATION = 14
Leave the spindle tool in the magazine and take a tool from the arm. The tools of the spindle
and of the arm are from the different magazines.
The sequence of this operation is the following. In this operation, the tool manager admits
2 sequences. Previously, while machining (when executing the T) the manager sends the
code: TMOPERATION=11 to take the tool from the magazine with claw 1.
1 Take the tool from the spindle with holder 2 and activate the mark SPDLTOCH2.
2 Leave the tool of holder 2 in the magazine and activate the mark CH2TOMZ.
3 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
TAKEPOS=-4 Ground tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=-4 Ground tool.
TAKEPOS=# Position occupied by the tool.
TAKEPOS=# Position occupied by the tool.
LEAVEPOS=# Position to leave the tool.
TAKEPOS=-1 Tool in the changer arm.
LEAVEPOS=# Magazine position to leave the tool.
MZID The lower portion of this register indicates the destination magazine
for the tool and the higher portion the source magazine for the tool.