Fagor CNC 8060, Руководство по установке

Страница: 661 / 698

Installation manual.
CNC 8060
CNC 8065
HARD
WARE.
15.
N
u
mber th
e digi
ta
l
inpu
ts and
o
u
tp
uts
o
f th
e CANope
n bus.
·661·
(R
EF
: 1709)
Configure the digital outputs.
The digital inputs and outputs are configured via machine parameters.
The configuration must meet the following requirements. If the parameters are not set
according to these requirements, the CNC will ignore it and it will number the digital outputs
sequentially according to the order of the modules in the bus.
• The parameters of all I/O nodes of the bus must be set; no node can be left undefined.
• The parameters of all the resources of a node must be set; no I/O can be left without a
number.
• The maximum number of logic blocks in the system will be 64, both for digital inputs and
digital outputs.
• The number of I/Os in a logic block must be other than zero and a multiple of 8 (8, 16,
24, 32, ...1024).
• The values of the base index must be comply with the formula "8n + 1" (i.e. 1, 9, 17, 25,
etc.).
• The blocks may be distributed at will within the range of resources managed by PLC
(1...1024). The PLC admits blanks, but the blocks cannot overlap; in other words, a PLC
digital input or output can only belong to a single node-module of the bus.
Parameter. Meaning.
NDOMOD Total number of digital output logic blocks.
Possible values: From 0 to 42 (by default; 0).
DOMODADDR Base addresses of the digital output logic blocks.
MNEMONIC Mnemonic of the logic block.
NODE Node number of the header to which the logic block belongs.
Possible values: From 1 to 125 (by default; 0).
BLOCK Number of the logic block.
Possible values: From 1 to 64 (by default; 0).
ADDRESS Base address of the logic block.
Possible values: From 1 to 1017 (by default, the first valid value).
NDO Number of digital outputs of the module.
Possible values: From 8 to 1024 (by default; 0).