QX1000 Manual II: Administrator's Guide
Administrator’s Menus
QX1000; (SW Version 5.3.x)
27
Enable SMS Service
enables the SMS service on the QX1000.
User Name
and
Password
text fields require the authentication
settings of the SMS server.
SMS Sender Address
requires the source address for the
QX1000 notification SMS. The address defined in this field will
be seen in the “From” field of the SMS delivered to the mobile
phone.
SMS Recipient Address
requires a destination mobile number
for a test SMS.
SMS Gateways
manipulation radio buttons allow to select
between pre-defined Clickatell SMS gateway and the custom
defined SMS gateways.
•
Clickatell
– this selection allows to use a pre-defined
SMS gateway. Selection enables the
API ID
text field
which indicates a Clicatell specific parameter obtained
from the server and should match on both sides.
•
Custom
– this selection allows to use a custom SMS
gateway. Selection requires following parameters to
be inserted:
Resource
text field requires the HTTP resource
name on the SMS gateway, for example:
/http/sms.cgi.
Parameters
text field requires the parameters to be
submitted to the resource address. The value of
this field represents a string with tokens (separated
by percent (%) symbols) inside. Each token
indicates a value of the certain field on this page.
The value is dependent on the SMS gateway
requirements. For example:
Fig. II-40: SMS Settings page
user=%username%&password=%password%&to=%to%&from=%from%&text=%text%
The tokens are the strings that have the following dependencies from the field in this page:
%username% – indicates the username defined in the field
Username
%password% – indicates the password defined in the field
Password
%to% - indicates the password defined in the field
SMS Recipient Address
%from% - indicates the password defined in the field
SMS Sender Address
%text% - indicates the SMS text generated by QX1000 (voice mail notification, event notification, etc.)
Server
text field requires the IP address or the host name of the SMS gateway.
Port
text field requires the port number of the SMS gateway.
Use Secure HTTP
checkbox enables access to SMS server via HTTPS. Checkbox selection enables a
Secure Port
text field that
requires the port number for HTTPS traffic.
Request Method
manipulation radio buttons allow to select the HTTP request method used by QX1000 the access the SMS gateway:
POST
or
GET
.
Send Test SMS
is used to send a test SMS to the defined SMS Recipient Address. This button will be enabled if correct values have been
submitted and saved on this page.
Firmware Update
This window allows updating the software of QX1000 by installing new firmware (image). Users registered at Epygi will receive a notice when new
firmware is available and will be able to download it from the Epygi Technical Support WEB page.
