Endress+Hauser Liquiline System CA80CR, Руководство по эксплуатации

Страница: 25 / 188

Liquiline System CA80CR Installation
Hauser
25
5.1.6 Mounting location
Note the following when mounting the sampler:
• Make sure that the wall has sufficient load-bearing capacity and is plumb.
• Mount the sampler on a level surface (with additional base).
• Protect the sampler from additional heating (e.g. from heaters).
• Protect the sampler from mechanical vibrations.
• Protect the device from corrosive gases, e.g. hydrogen sulfide (H
₂
S).
• Make sure that the fluid can drain freely without any siphoning effects.
• Make sure air can circulate freely on the front of the housing.
• Make sure that analyzers supplied in an open state (i.e. analyzers without a door) are installed
only in enclosed areas or in an enclosure or similar.
5.1.7 Mechanical connection
Connecting the liquid-bearing suction lines
First connect the liquid-bearing suction lines and visually inspect the hoses before
establishing the connection to the power supply.
The reagents used can be detrimental to health. Pay attention to the information in the
reagent safety data sheets.
Self-priming
Connect the intake hose supplied (1.5 m) to ("sample") (see hose connection diagram), and
guide the hose through the analyzer's hose gland to the outside.
Ensure that only sample is supplied, as otherwise there is a risk of blockage. The customer
must guarantee a constant and sufficient volume of sample.