Elliott E190, Руководство по эксплуатации и обслуживанию

Страница: 48 / 358

Operating/Outrigger Controls E145/E190 EEC-0035
V1.2
Operating/Outrigger
Controls
Unwarranted use of the override switch can result in harm to the aerial unit, as
well as pose a threat to property and people using and located near the aerial
device.
WARNING- NEVER use the override switch to overload the aerial or operate in a
range not permissible according to the range diagram.
G. Emergency Stop
Button must be pulled out for aerial operation. Pushing this button while Master
Power switch is in the ON position will stop the truck engine; however, pushing
button with the Master Power switch in the OFF position will not affect truck
operations.
H. Truck Throttle Control Switch: This switch is used to control the truck’s engine
throttle.
1. Increase throttle speed -Press and hold switch to the high position. The
engine speed increases incrementally to the maximum speed to order the
hydraulic pump at the maximum flow.
2. Decrease throttle speed-P ress and hold switch to the low position. The
engine speed decreases incrementally down to idle speed.
3. Intermediate throttle setting- Release switch while engine speed is
increasing or decreasing.
I. Truck Start Switch
This is a momentary switch used to start or stop the truck engine. Hold the switch in
the start position to activate the starter. Release the switch as soon as the engine
starts. Activate and hold the switch in the Stop direction to shut the truck off. Once
the engine stops completely stops running, release the switch. If this switch is
released while engine is still turning over, the truck will restart.
J. Remote Control Switch
On units equipped with remote controls, this switch activates the remote controls.
Set the switch to the “ON” position to activate the remote controls. Set this
position to the “OFF” position to turn remotes off. See operating instructions in
the “Optional Remote Controls” section of this manual.