Elliott E190, Руководство по эксплуатации и обслуживанию

Страница: 209 / 358

Five Section Boom Operation-aerial EEC-0080 V1.3
Five Section Boom Operation
F. Inspect all zerks and grease paths in pins to ensure proper grease flow. Clean and
replace as required.
Five Section Boom Assembly
A. Assemble sheaves into 5
th
section sheavecase. Top sheave is to be installed to the
left hand side of the boom with the spacer to the right hand side.
B. Attach rear wear pads to the bottom of the 5
th
section. Using Loctite 242 blue, Loctite
all wear pad mounting capscrews.
C. Position 5
th
section boom in front of the 4
th
section boom ready to slide together.
Route 3/4/5 extend cables through 4
th
section boom with the threaded end of the
cable at the rear of the 4
th
section and the button end out the front, loop the front
button end of the 3/4/5 cable beyond its anchor point on the 5
th
section and install
button end into 5
th
section boom.
D. Install 5/4/3 retract cable button end into anchor point in 5
th
section and install
keeper plate and capscrews, keeper plate will lock both the extend and retract
cables in place. Coil 5/4/3 retract cables temporarily into 5
th
section.
4
th
Section Cable Anchor Cable Button Cable Thread
3/4/5 Extend