Elliott E190, Руководство по эксплуатации и обслуживанию

Страница: 83 / 358

Remote Control EEC-0001
V1.0
Remote Control
In order to maintain a safe machine, a regular function check of the
platform/radio control system is necessary. This check shall include verifying all safety
features are operational before using this system. Controls are equipped to be
connected via hard wired communication cable or be used as a radio remote
control.
Never allow anyone to operate the system until the operator has read all
instructions and has become completely familiar with the total remote control system. In
the event any unexplained, unpredicted, or incorrect operation occurs, immediately shut
down the complete system and investigate. This includes shutting down all electronics,
hydraulics, PTO’s and engines. Never resume operation unto the problem has been
corrected.
When not using the remote controls, switch the remote off by pressing the
Emergency Stop Button. Verify that the button locks itself in, and then make sure the
remote control power switch is switched to the off position. This will prevent inadvertent
operation of the aerial device by activation of the remote levers.
Operation
If the truck is running when the remotes are switched on, the truck engine will
shut off and the truck will need to be restarted using the remote controls. This can be
done by following the instructions found later in this section. The remote control’s
system is designed for use either single or multiple functions at once and is fully
proportional. See lever and switch designations found in the remote section of this text
for specifics on operation of each lever and switch.
Aerial device and Option Function Levers
This remote is equipped with six two-way levers for the following boom functions;
boom swing, telescope, spare, aux winch, main winch and boom lift. Additionally, and
eight toggle switches and two buttons to operate the following functions: Truck
Start/Stop, Tool Circuit, Engine Throttle, Emergency Pump, Aux Winch/ Main winch