Elliott E190, Руководство по эксплуатации и обслуживанию

Страница: 345 / 358

11
PRE-OPERATION OF TOOL
Before attempting to run or use the REL-10-I, REL-10-I-SA or connected tools, check
all connections, including hoses, and couplings. (See WARNINGS on pages 4-7)
Wear all safety items required, and make sure that the working area is clear of
obstructions and non-essential personnel.
DO NOT connect hoses or fittings to pump before reading all of
the instructions in this section.
Ensure power source is OFF , hydraulic flow is turned OFF .
Failure to comply with this warning can result in severe injury or death.
WARNING
HYDRAULIC FLUIDS
All hydraulic fluids that meet these listed specifications or the listed HTMA
specifications may be used for this tool.
S. U. S.
@ 100
O
F (38
O
C) ........................................................................... 140 TO 225
@ 210
O
F (99
O
C) ......................................................................... 40 minimum
FLASH POINT ......................................................... 340
O
F min. (170
O
C min.)
POUR POINT .. ..................................................... -30
O
F min. (-34
O
C min.)
HOSES AND FITTINGS
There exists the potential for shock in using anything other
than certified nonconductive hoses and hydraulic oil with
dielectric properties, when using system components near
energized electrical lines. Failure to recognize these conditions
could cause electrocution.
Hoses and fittings used with this tool must comply with S.A.E. J1273 which covers
recommended practice for selection, installation, and maintenance of hose and hose
assemblies. The
correct hoses and fittings are available from your supplier.
WARNING: Failure to comply with these warnings could result in severe bodily injury.
WARNING
If you have any questions regarding the information found in this manual please
contact the supervising authority, or
RELIABLE EQUIPMENT before continuing.
Phone: 215-357-3500 Toll Free: 800-966-3530 Fax: 215-357-9193
NOTICE