Elliott E190, Руководство по эксплуатации и обслуживанию

Страница: 349 / 358

15
USE ALL APPROPRIATE AND APPLICABLE PERSONAL
SAFETY PROCEDURES AND EQUIPMENT AS REQUIRED
BY THE OPERATING COMPANY.
I
nspect, set-up and connect the tool as described on the
previous pages. NOTE: AN IN LINE FOUR WAY CONTROL
VALVE IS REQUIRED FOR DOUBLE ACTING OPERATION.
WARNING:
DO NOT connect or disconnect the tool, hoses,
or fittings while the tool is running, hot, or under pressure.
Tool damage, serious injury or burns may result.
Replace all parts that show signs of wear or damage.
A damaged or improperly assembled tool may injure operator and/
or nearby personnel.
Set up desired operation. (ie. crimp, cut, or spearing).
Review and understand all operation and safety guidelines relating
to the operation to be performed.
Ensure that valve is in the
RETRACT position before initiating
hydraulic power souce.
Activate the
REL-10-I-SA/D by moving valve handle to the
LEFT/ ADVANCE position.
Operate in-line control valve to activate double acting tool and begin
cutting or crimping procedure.
When relief valve popping occurs desired pressure has been
achieved and operation should be complete.
NOTE:
Holding control valve in the ADVANCE position after relief
valve has popped will cause unnecessary wear on relief valve
and pump assembly.
Use the in-line control valve to open or retract tool jaw/blades.
Repeat as necessary.
Move valve handle to RIGHT/
RETRACT to stop pressure.
Valve should be in RIGHT/ RETRACT position when not in use.
WARNING:
ALWAYS ensure valve handle is in the retract
position and hydraulic source is turned off before you
connect or disconnect the tool, hoses, or fittings while the
tool is running, hot, or under pressure.
Serious property damage, injury, or burns may result.
REL-10-I-SAD REL-10-I-SAD
REL-10-I-SAD REL-10-I-SAD REL-10-I-SAD D/A OPERA
D/A OPERA
D/A OPERA D/A OPERA D/A OPERATION
TION
TION TION TION
LOW PRESSURE PORTS
(TO POWER SUPPLY)
H/P SINGLE ACTING
PRESSURE PORT
VALVE HANDLE
REL-10-I
INTENSIFIER
PVA-00L3
3-WAY VALVE
Move valve handle
to desired action
LEFT/ADV (advance)
or RIGHT/RET (retract) return
upon completion
of operation.
PVA-00L3
3-WAY VALVE
H/P DOUBLE ACTING
PRESSURE PORT
DOUBLE ACTING
RETURN PORT
LEFT RIGHT
NOTICE
If you have any questions regarding the information found in this manual please
contact the supervising autority, or RELIABLE EQUIPMENT before continuing.
Phone: 215-357-3500 Toll Free: 800-966-3530 Fax: 215-357-9193