379
Data Display/Edit/Management
Transferring data via
Infrared data exchange
c
Set the receiving FOMA terminal to standby, and
keep approx. 20 cm or less between the FOMA
terminals.
c
Place the FOMA terminals on a stable surface,
such as a table, so that the infrared data ports
are aligned on the same level and facing each
other.
c
Do not move the FOMA terminals during data
exchange.
c
Do not place anything between the FOMA
terminals or cover the infrared data ports.
c
If data exchange is finished unsuccessfully,
adjust the positions then retry the exchange.
c
The FOMA terminals may not communicate
successfully if they are placed under direct
sunlight, directly under a fluorescent light, or
close to other infrared equipment.
Transferring data via iC
communication
Put the FeliCa mark "
" of the sending FOMA
terminal close to the FeliCa mark "
" of the
receiving FOMA terminal.
c
Data transmission may not be smooth
depending on the FOMA terminal of the other
party. Move FOMA terminals so that the FeliCa
marks
of the sender and the receiver get
close or distant, or move them to the right, left,
up and down to be shifted to the opposite
direction.
Transferring data via cable
connection
c
To transfer data, you need the software such as
DoCoMo keitai datalink (p.474).
c
Before transferring data, set "USB mode setting"
to "Communication mode".
→
p.374
Note on transferring data
Before data transfer
c
You cannot transfer data while another function
is running. Exit all other functions before
transferring. You cannot run another function
while transferring data.
c
You cannot transfer data while making/receiving
a voice call/videophone call/PushTalk call or
using i-mode, packet communication or 64K data
communication.
→
p.502
c
You cannot transfer data while Dial lock, Self
mode, Omakase Lock or Keypad lock is set. iC
communication is unavailable while IC card lock
is set.
c
You cannot receive data stored in the phonebook
while "Restrict dialing" is set. However, you can
send data with "Restrict dialing" and data in "My
Profile".
c
Whether you can transfer data may depend on
the status of the other party's FOMA terminal. If
you transfer with a terminal whose model is
different from yours, it may not reflect the
settings of received messages or bookmark
folder tree, or may not receive a Deco-mail
message correctly.
c
The data transfer function via Infrared data
exchange, cable connection or iC
communication conforms to the IrMC1.1
standard. You may be unable to exchange data
with a terminal or PC that does not conform to
IrMC1.1. Some data may not be transferred
correctly even if the terminal or application of the
other party conforms to IrMC1.1.
c
When transferring a still image, melody, movie/
i-motion, PDF document, PushTalk phonebook
or ToruCa via cable connection, which does not
comply with IrMC, you need the transferring
software compatible with FOMA N904i.
Appro
x. 20cm or less
Infrared data
port
Within the
range of ±15˚
■
Important
c
Ensure that the FOMA terminal and a PC are
properly connected. An improper connection may
not only prevent data transfer but may also result
in data loss. Install the N904i communication
setting file (driver).
→
p.473
c
Attempting to transfer data with the FOMA
terminal's battery low or empty may not only
prevent data transfer but may also result in data
loss. Make sure that the FOMA terminal's battery
is fully charged. Also check the PC's power.
c
All data on the FOMA terminal may be deleted if
an error occurs while transferring all from a PC to
the FOMA terminal. Before transferring all, check
the cable connection, the FOMA terminal's battery
level and the PC's power.
