46
Before Using the Handset
■
When "
" appears
You are out of service area or in a place where radio waves do not reach. Move until the
signal strength indicator e.g. "
" appears. The reception levels appear as follows:
■
When PIN1 code entry set is set to "ON"
The PIN1 code entry screen appears.
→
p.160
■
When Auto reset total cost is set to "ON"
The PIN2 code entry screen appears.
■
If the initial settings screen appears
Perform the initial settings.
→
p.46
e
When the FOMA card (UIM) is exchanged, enter your 4 to 8-digit security code after turning the power on. The
standby screen appears after the correct security code is entered. The power turns off if you enter the wrong
security code five times (however, you will be able to turn the power back on).
Turning the FOMA terminal off
a
y
(2 seconds or longer)
The shutdown message "ARRIVEDERCI" (See you) appears and the power is turned off.
e
Signal strength is not stable when you talk on your FOMA terminal while moving. Due to the nature of digital transmissions,
calls may end suddenly. Wherever possible, you should always ensure that "
" is shown when using the FOMA terminal.
e
After turning the FOMA terminal off, wait a few minutes before turning the FOMA terminal back on.
〈
Select language
〉
MENU15
Switching Language Mode
You can switch language mode between Japanese and English that is used for showing function
names or messages on the display or indicator display.
a
i
X
"SETTINGS"
X
"Display"
X
"Select language"
X
"English"
e
When the FOMA card (UIM) is inserted, the Select language setting saved in the FOMA card (UIM) is applied.
e
Selecting "English" for "Select language" gives you two options "ON" and "OFF" for "Display" under "Clock display"
and for "Info notice setting".
〈
Initial setting
〉
Performing Initial Settings
After turning the FOMA terminal on, set "Set time", "Change security code", "Character size", "Permit to
send loc.", "Keypad sound", "Neuropointer" ("Simple" only) and "PushTalk Caller ID" as initial settings.
d
If you have set any of the functions, the function's setting screen does not appear.
d
After Steps 1 to 8 are performed, the initial setting screen no longer appears. Even if you perform "Reset
settings" after those initial settings are completed, the initial setting screens do not appear.
d
When "PIN1 code entry set" is set to "ON", the PIN1 code entry screen appears after you turn the FOMA
terminal on. Enter the correct PIN1 code to show the initial setting screens.
→
p.160
NOTE
NOTE
■
To change from Japanese to English
■
To change from English to Japanese
X
"English"
X
"
日本語
"
NOTE
For same guidance messages played for callers, you can switch the language mode between Japanese and English.
→
p.463
Standby
Good
Poor
Default setting
Japanese
バイリンガル
English
メニュー15
Japanese
ディスプレイ
Japanese
Select language
英語
Menu15
日本語
Display
English