Dell BigIron RX Series, Руководство по настройке

Страница: 1360 / 1458

1284 BigIron RX Series Configuration Guide
53-1002253-01
Continuous System Monitor
51
Sep 13 15:01:29:E:System: ALARM: LP9/TM2 has shutdown (TM DRAM CRC: LP9/TM2 (Reg:
0xa50c, Value: 0x7) (shutdown))
TX_BUFFER
Tx stuck buffer is end result of ingress DRAM CRC, once its stuck, it will stop forwarding traffic.
Here is an example from Syslog.
Sep 13 15:01:29:E:System: ALARM: LP16/TM1 re-initialized (TM TX BUFFER Stuck:
LP16/TM1 (Reg: 0x400000b4, Value: 0x1de) (reinit))
MP_DX
This event type is checking the MP CPU communication with standby MP and line cards via internal
ethernet connectivity. Here is an example from Syslog.
Nov 19 20:21:03:E:System: ALARM:MP DISCO-DX Failure (error mask: 0x2)
LPM_ERR
Each NP on an LP has external Longest Prefix Match memory (LPM) attached to it. To ensure the
integrity of the data the NP has implemented ECC associated with this external memory. Sysmon
periodically scans these registers to detect an error condition. Here is an example from Syslog.
Feb 3 20:13:00:E:System: ALARM:LPM Error LP3/NP1 - set 3 cause ECC address 0x55d0
FE_RW
This event type tests write and read access to the switch fabrics. A Syslog message is generated to
indicate a SFM FE failure. Here is an example from Syslog.
Sep 2 14:00:39:E:System: ALARM:FE Read-Write Test Error: LP1/TM2 Reg 0x18, Read
0x4 != Written 0xffffffff
MBridge FPGA
The event MBRIDGE FPGA is monitoring the MP MBridge FPGA status. If MBridge FPGA failure is
detected then send the sysmon error log and initiate the MP “switchover”. Here is an example from
Syslog.
if, MBridge Failure with valid address range (0xb000000 to 0xb1ffffff)
Feb 3 20:13:00:E:System: ALARM: MP MBridge FPGA read Failure (Read error Address:
0xb0000020)
if, MBridge Failure with invalid address range
Feb 3 20:13:00:E:System: ALARM: MP MBridge FPGA read Failure (Read error Address:
0xffffffff)