Dell BigIron RX Series, Руководство по настройке

Страница: 1214 / 1458

1138 BigIron RX Series Configuration Guide
53-1002253-01
Clearing BGP4+ information
45
NOTE
For the suppress-map, advertise-map, and attribute-map parameters, the route map must already
be defined.
To remove an aggregate route from a BGP4 neighbor advertisement, use the no form of this
command without any parameters.
Using route maps
You can use a route map to filter and change values in BGP4+ routes. Currently, you can apply a
route map to IPv6 unicast routes that are independent of IPv4 routes.
To configure a route map to match on IPv6 unicast routes, enter commands such as the following.
BigIron RX(config)# router bgp
BigIron RX(config-bgp)# address-family ipv6 unicast
BigIron RX(config-bgp-ipv6u)# neighbor 2001:eff3:df78::67 remote-as 1001
BigIron RX(config-bgp-ipv6u)# neighbor 2001:eff3:df78::67 route-map in map1
BigIron RX(config-bgp-ipv6u)# exit
BigIron RX(config)# ipv6 prefix-list ipv6_uni seq 10 permit 2001:eff3::/32
BigIron RX(config)# route-map map1 permit 10
BigIron RX(config-routemap-map1)# match ipv6 address prefix-list ipv6_uni
This example configures a route map named “map1” that permits incoming IPv6 unicast routes
that match the prefix list named “ipv6_uni” (2001:eff3::/32). Note that you apply the route map
while at the BGP4+ unicast address family configuration level.
Clearing BGP4+ information
This section contains information about clearing the following for BGP4+:
•
Route flap dampening.
•
Route flap dampening statistics.
•
Neighbor information.
•
BGP4+ routes in the IPv6 route table.
•
Neighbor traffic counters.
NOTE
The clear commands implemented for BGP4+ correspond to the clear commands implemented for
IPv4 BGP. For example, you can specify the clear ipv6 bgp flap-statistics command for IPv6 and the
clear ip bgp flap-statistics for IPv4.
Removing route flap dampening
You can un-suppress routes by removing route flap dampening from the routes. The switch allows
you to un-suppress all routes at once or un-suppress individual routes.
To un-suppress all the suppressed routes, enter the following command at the Privileged EXEC level
or any of the Config levels of the CLI:
BigIron RX# clear ipv6 bgp dampening