Dell BigIron RX Series, Руководство по настройке

Страница: 1295 / 1458

BigIron RX Series Configuration Guide 1219
53-1002253-01
Configuring OSPFv3
48
BigIron RX(config-ospf6-router)# metric-type type1
Syntax: [no] metric-type type1 | type2
To restore the metric type to the default value, use the no form of this command.
Configuring external route summarization
When the Brocade device is an OSPF Autonomous System Boundary Router (ASBR), you can
configure it to advertise one external route as an aggregate for all redistributed routes that are
covered by a specified IPv6 address range.
When you configure an address range, the range takes effect immediately. All the imported routes
are summarized according to the configured address range. Imported routes that have already
been advertised and that fall within the range are flushed out of the AS and a single route
corresponding to the range is advertised.
If a route that falls within a configured address range is imported by the Brocade device, no action
is taken if the device has already advertised the aggregate route; otherwise, the device advertises
the aggregate route. If an imported route that falls within a configured address range is removed by
the device, no action is taken if there are other imported routes that fall with in the same address
range; otherwise the aggregate route is flushed.
You can configure up to 32 address ranges. The Brocade device sets the forwarding address of the
aggregate route to zero and sets the tag to zero.
If you delete an address range, the advertised aggregate route is flushed and all imported routes
that fall within the range are advertised individually.
If an external link state database overflow (LSDB) condition occurs, all aggregate routes are flushed
out of the AS, along with other external routes. When the Brocade device exits the external LSDB
overflow condition, all the imported routes are summarized according to the configured address
ranges.
NOTE
If you use redistribution filters in addition to address ranges, the Brocade device applies the
redistribution filters to routes first, then applies them to the address ranges.
NOTE
If you disable redistribution, all the aggregate routes are flushed, along with other imported routes.
NOTE
This option affects only imported, type 5 external routes. A single type 5 LSA is generated and
flooded throughout the AS for multiple external routes.
To configure the summary address 2201::/24 for routes redistributed into OSPFv3, enter the
following command.
BigIron RX(config-ospf6-router)# summary-address 2201::/24
In this example, the summary prefix 2201::/24 includes addresses 2201::/1 through 2201::/24.
Only the address FEC0::/24 is advertised in an external link-state advertisement.
Syntax: summary-address < ipv6-prefix >/< prefix-length >
You must specify the < ipv6-prefix > parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373.