Compaq External RAID Controller & Subsystem Infortrend, Руководство по эксплуатации

Страница: 95 / 347

Infortrend
5-27
Deleting a Channel ID
Press ENT on an existing host channel
ID you want to delete. Press
▼
or
▲
to
choose “Delete Channel SCSI ID," then
press
ENT .
Press ENT for two seconds to confirm.
IMPORTANT!
•
Every time you make changes to channel IDs, you must reset the
controller for the configuration to take effect
.
• The reserved IDs for SCSI-based controllers are shown below:
Single controller configuration (SCSI-based controllers):
Drive channels – “7”
Redundant controller configuration:
Drive channels – “8” and “9”
For IDs reserved in different controller configurations, please refer to the
hardware manual that came with your system. For controllers
connected through back-end PCBs, firmware can detect its board type
and automatically apply the preset IDs. There is no need to set IDs for
these models.
• In single controller mode, you should set the Secondary Controller’s ID
to “NA.” If a secondary controller exists, you need to set an ID for it on
each of your drive channels
.
• Multiple target IDs can be applied to Host channels while each Drive
channel has only one or two IDs (in redundant mode)
.
• At least a controller’s ID has to be present on each channel bus .
Setting a SCSI Channel’s Primary ID - Drive Channel
Press ENT for two seconds to enter the
Main Menu. Press
▼
or
▲
to select
"View and Edit SCSI Channels," then
press
ENT .
View and Edit
SCSI Channels
↕
Delete ID=2
Primary Ctlr ?
Delete Channel
SCSI ID ..