Burkert FLOWave S 8098, Руководство по эксплуатации

Страница: 75 / 192

75
SAW sensor - Parameter
Type 8098
By default, the monitoring of the volume flow rate is disabled, and the diagnostics are all disabled.
To activate the monitoring of the volume flow rate, do the following:
→ Select the device in the navigation area.
→
SAW sensor
→ Parameter
→
Stand. meas. values
→ Volume flow
→
Limits
→ Active
→
Select Yes .
The monitoring of the volume flow rate is active and the device status will change depending on the
limits that have been set.
→ You can configure the behaviour of an analogue output depending on the status of the device. See chpt.
16.3.3 Configuring the behaviour of an analogue output depending on the status of the device.*
)
→
You can configure a digital output to switch every time a specific event is generated. See chpt. 16.5.1
Configuring a digital output as an on/off output. *
)
→ To enable the monitoring, i.e. to be informed when the value of the volume flow rate is outside the normal
range, enable the diagnostics. See chpt. 10.9 Activating the diagnostics functions.
*
)
Only variant with outputs.
13.4.6 Deactivating the monitoring of the volume flow rate
By default, the volume flow rate values are not monitored.
If the monitoring of the volume flow rate is active, do the following to deactivate it:
→
Select the device in the navigation area.
→
SAW sensor
→
Parameter
→
Stand. meas. values
→
Volume flow
→
Limits
→
Active
→ Select
No
.
The monitoring of the volume flow rate is inactive.
English