Burkert FLOWave S 8098, Руководство по эксплуатации

Страница: 154 / 192

154
Outputs - Parameter
Type 8098
To change the damping level of the values transmitted on an analogue output, do the following:
→ Select the device in the navigation area.
→
Outputs
→ Parameter
→
Output 1: analog or Output 3: analog
→ Damping
→
Select the damping level.
The damping level is changed.
16.3.3 Configuring the behaviour of an analogue output depending on
the status of the device
Depending on the status of the device, the analogue output:
• can continue to transmit the process values.
• or, can transmit and hold the last process value (not available if measurements are not possible)
• or, can transmit a 22 mA current (not available if measurements are not possible)
• or, can transmit a 3.6 mA current (not available if measurements are not possible)
•
or, can transmit any preset current value (i.e. a Forced value ).
To change the behaviour of an analogue output depending on the status of the device, do the following:
→
Select the device in the navigation area.
→ Outputs
→
Parameter
→ Output 1: analog or Output 3: analog
→
Behaviour
→ Select Measurement value not ascertainable, Failure , Out of specification or Maintenance required
The current behaviour is displayed.
→ Select the behaviour associated to the device status.
→
If the behaviour is set to Forced value , set the current value to any value in the range 3.5 – 23 mA.
The behaviour of an analogue output is changed.
English