Burkert FLOWave S 8098, Руководство по эксплуатации

Страница: 57 / 192

57
General settings - Parameter
Type 8098
10.8 Reading out the low warning limit for the voltage of
the internal battery
The device has a small battery to store energy so that the time system can run for 7 days when the device is
not powered.
To read out the value of the low warning limit, do the following:
→ Select the device in the navigation area.
→
General settings
→ Parameter
→
Alarm limits
Warning battery voltage low
can be read.
10.9 Activating the diagnostics functions
WARNING
Risk of injury due to non-conforming adjustment.
Non-conforming adjustment could lead to injuries and damage the device and its surroundings.
▶
The operators in charge of adjustment must have read and understood the contents of the Operating
Instructions.
▶
In particular, observe the safety recommendations and intended use.
▶
The device/installation must only be adjusted by suitably trained staff.
By default, all the diagnostics events related to the process, the electronics or the sensor, the messages
related to the monitoring of the process values (e.g. the flow rate) and the messages related to problems on
the device and on büS are disabled.
To activate the diagnostics, do the following:
→ Activate the needed diagnostics events. See chpt. 13.10.
→
Activate the monitoring of the process variables that must be monitored. See chpt. 13.4.5 , chpt. 13.5.5,
chpt. 13.6.5 , chpt. 13.7.3 , chpt. 13.8.3 , chpt. 13.9.4.
→ Select the device in the navigation area.
→
General settings
→ Parameter
→
Diagnostics
→ Select ON
→
Restart the device.
The needed diagnostics are active.
English