Baroness LM551, Руководство по обслуживанию, Страница: 148 / 213

The lock nut uses a 1/2 inch wrench, and the
traction adjusting cam uses a 1/4 inch
wrench.
Follow the steps below to adjust the neutral
position.
Loosen the lock nuts.
Slowly rotate the traction adjusting cam
until all tires stop.
If the tires move in the direction of
forward travel, rotate the traction
adjusting cam clockwise.
If the tires move in the direction of
backward travel, rotate the traction
adjusting cam counterclockwise.
Find the position where all tires stop, and
then, while holding the traction adjusting
cam in place, secure it with the lock nut.
1
2
3
LM551_SP0_076
Adjusting The Neutral Position of The Piston Pump_001
1 Lock nut
2 Traction adjusting cam
3 Cam lever
Check that the tires do not move.
Adjustment of the Push-Pull Cable
The range of motion of the push-pull cable may
change due to deterioration of the traveling
pedal.
Inspect it and, if necessary, make adjustments.
Apply the parking brake, and then stop the
engine.
Check that the piston pump has been
adjusted to neutral position.
Adjust the lock nut so that the wire bracket
comes to the center of the push-pull cable
piston pump side adjustment bolt.
[1]
[2]
･
･
7.
1.
2.
3.
Tighten the lock nut.
1
2
3
5
4
8zwqsz-001
Adjustment of the Push-Pull Cable_001
1 Piston pump
2 Push-pull cable
3 Piston pump side adjustment bolt
4 Wire bracket
5 Lock nut
Adjust the push-pull cable traveling pedal
side adjustment bolt with the lock nut so that
the forward travel pedal height from the floor
can be 148.0 mm (5.83 in).
Tighten the lock nut.
1
2
3
3
8zwqsz-002
Adjustment of the Push-Pull Cable_002
4.
5.
6.
LM551
Main Vehicle
Page 6-4
Adjustment