Avaya G700, Установка и обновление, Страница: 513 / 808

Install new firmware on the G700 Media Gateway
Issue 10.2 May 2007 513
Note:
Note:
The VoIP processor on the motherboard is upgraded using the same firmware
image file as the VoIP media modules; for example, the file mm760v8.fdl is
vintage #8.
5. Check the FW VINTAGE column for vintages of each of the installed media modules:
MM710, MM711, MM712, MM714, MM716, MM717, MM720, MM722, and/or MM760 to see
if they match the FW vintages in the planning forms.
If not, you must upgrade them, as well.
Install new firmware on the G700 Media Gateway
The procedures in this section install firmware on the G700 processors and media modules.
Installing new firmware on the P330 stack processor
To install P330 stack processor firmware
1. See Accessing the P330 Stack Processor .
2. At the P330-1(configure)# prompt, type
copy tftp SW_image <file> EW_archive <ew_file>
<tftp_server_address> <Module#>
where
<file>
is the full-path name for the image file with format and vintage number
similar to viisa3_8_2.exe,
<ew_file>
is the full-path name for the embedded web application file with format similar
to p330Tweb.3.8.6.exe,
<tftp_server_ip_address>
is the IP address of the TFTP server, and
<Module#>
is the number, 1 through 10, of the media gateway in the stack. If there is only
one G700 media gateway, the number is
1
.
3. Verify that the download was successful when the prompt returns:
a. type
show image version <module #>
and check the version number in the
Version column for Bank B.
b. type
dir <module #>
and check the version number in the ver num column for the
EW_Archive file.
4. Type
reset <module #>
.