Avaya G700, Установка и обновление, Страница: 313 / 808

Ensuring the MGP default gateway IP address is set
Issue 10.2 May 2007 313
Note:
Note:
A TFTP server must be accessible over the LAN from the gateway you are
upgrading.
3. Click Schedule to set up the upgrade schedule or Run Now to run the upgrades
immediately.
Ensuring the MGP default gateway IP address is set
Communication Manager release 4.0 requires that the built-in VoIP module of the G700 Media
Gateway has a default gateway IP address. To ensure that this IP address is set, perform the
following steps:
1. Log into the G700 Media Gateway console port (see Logging in to the P330 Stack
Processor with a Direct Serial Connection on page 64).
2. Type
configure
to obtain the P330-1(configure)# prompt.
3. At the P330-1(configure)# prompt, type
session mgp
.
4. At the MG-???-1(configure)# prompt, type
show ip route mgp.
The list of mgp routes appears.
5. Check that a Gateway IP address exists for Destination
0.0.0.0
.
6. If a Gateway IP address does not exist, type, at the MG-???-1(configure)# prompt,
set
ip route 0.0.0.0 0.0.0.0 <IP_address>
, where
<IP_address>
is the default
gateway IP address.
After you reboot the media gateway, the IP address is active and available.
MG-001-1(super)# show ip route mgp
DESTINATION MASK GATEWAY INTERFACE (F/C/U)
--------------- --------------- --------------- ---------- -----------
0.0.0.0 0.0.0.0 135.9.80.254 motfec0 (3/0/165)
135.9.80.0 255.255.255.0 135.9.80.88 motfec0 (101/0/0)
MG-001-1(super)#