Avaya G700, Установка и обновление, Страница: 609 / 808

Upgrade the firmware on the G700 Media Gateway
Issue 10.2 May 2007 609
Installing new firmware on the media modules
For upgrades of active media modules, you need to take the media modules out of service
before initiating the upgrade process. To do this, go to a SAT session on the primary controller
and issue a
busyout
command.
Note:
Note:
Skip this busyout procedure if the media modules are not in service; for example
during an initial installation.
To busyout board (for active media modules)
1. Go to a SAT session on the primary controller and enter the command,
busyout board v x
where
x
is the slot number of the media module to be upgraded.
2. Verify the response,
Command Successfully Completed
3. Repeat for each media module to be upgraded.
To install media module firmware
1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on
the G700 motherboard).
This VoIP module does not occupy a physical position like other media modules.
2. At the P330-1(configure)# prompt, type
session mgp
.
3. At the MG-001-1(super)# prompt, type
configure
to change to the configuration mode.
4. Type
copy tftp mm-image v <slot #> <filename mm>
<tftp_server_ip_address>
where
<slot #>
is the slot of the specific media module,
<filename mm>
the full-path name of the media module firmware file in a format such as
mm712v58.fdl, and
<tftp_server_ip_address>
is the ip address of the S8300.
Two or three minutes will be required for most upgrades. The VoIP media module upgrade
takes approximately 5 minutes. Screen messages indicate when the transfer is complete.
5. After you have upgraded all the media modules, verify that the new versions are present.
At the MG-???-1(configure)# prompt, type
show mg list_config
The list of software appears.