Avaya G700, Установка и обновление, Страница: 650 / 808

Manual upgrade of an existing S8300B or S8300C and G700 to R4.0
650 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
The following steps activate the service pack.
1. Click Start > Run to open the Run dialog box.
2. Type telnet 192.11.13.6 and press Enter.
3. Log in as either craft or dadmin .
4. Type
update_unpack
and press Enter .
5. Select the number corresponding to the service pack file. (For example,
00.0.339.4-xxxx.tar.gz
). Press Enter .
6. Type
update_show
and press Enter to list Communication Manager files to verify that the
new service pack file was unpacked.
7. Type
update_activate update
, where
update
is the release or issue number of the
latest service pack file. (For example,
00.0.339.4-xxxx
. Do not use the .tar.gz extension
at the end of the file name). Press Enter .
The media server may reboot. If it reboots, it also may display the message
/opt/ecs/sbin/drestart 2 4 command failed
.
Ignore this message. You must wait until the restart/reset completes before entering
additional commands.
The media server displays a message that the service pack was applied.
8. Type
update_show
again and press Enter to list Communication Manager files to verify
the service pack file was activated.
9. Enter y in response to the question,
Commit this software?
Copying Files to the S8300 hard drive
You must copy the remaining required files to the pub directory on the S8300 hard drive. This
includes, but is not limited to:
●
Post-upgrade software service pack
●
License file
●
Avaya authentication file
●
New firmware files
●
Security updates
●
IA770 service packs or RFUs