Avaya G700, Установка и обновление, Страница: 571 / 808

Replacing the S8300A
Issue 10.2 May 2007 571
Note:
Note:
The number of processes (65/65) may vary depending on the configuration. For a
normal state, the second number should not be greater than the first number. For
example, the numbers 64/65 UP would indicate that a process did not come up
and should be investigated before proceeding.
10. Close the telnet session.
To install the pre-upgrade service pack when the current release is 2.x.
Note:
Note:
Use a telnet session to install and activate the service pack file.
The following steps activate the service pack.
1. Click Start > Run to open the Run dialog box.
2. Type telnet 192.11.13.6 and press Enter.
3. Log in as either craft or dadmin .
4. Type
update_unpack
and press Enter .
5. Select the number corresponding to the service pack file. (For example,
00.0.339.4-xxxx.tar.gz
). Press Enter .
6. Type
update_show
and press Enter to list Communication Manager files to verify that the
new service pack file was unpacked.
7. Type
update_activate update
, where
update
is the release or issue number of the
latest service pack file. (For example,
00.0.339.4-xxxx
. Do not use the .tar.gz extension
at the end of the file name). Press Enter .
The media server may reboot. If it reboots, it also may display the message
/opt/ecs/sbin/drestart 2 4 command failed
.
Ignore this message. You must wait until the restart/reset completes before entering
additional commands.
The media server displays a message that the service pack was applied.
8. Type
update_show
again and press Enter to list Communication Manager files to verify
the service pack file was activated.
9. Enter y in response to the question,
Commit this software?