Adtech 4 Series, Руководство по обслуживанию

Страница: 68 / 155

ADTECH 4 series CNC System (maintainance Manual)
64
001
002
003
007
Inp Speed(mm/min)
InpStartSpeed(mm/min)
InpAcceleration(mm/sec)
MaxFeedSpeed(mm/min)
004 ZeroReturn Mode
005 IO FilterWave(1~8)
11.2 Genal parameters (P1.)
Range : 1~9999, 1~9999, 1~8000, 1~9999
Unit : mm/min,mm/min,mm/sec,mm/min
Authority : Operation admin or super
Default : 3000,200,1000,3000
Effective time : Instant
Note
The feeding instructions such as G01, G02 and G03 move at the speed of F
instruction. If the F instruction isn‘t specified in the program, the above
instructions move at the speed set by this parameter. If the F instruction is
specified, this parameter will be invalid.
The maximum feeding speed restricts the F instruction during processing, i.e. no
matter what F is set to, the actual speed can‘t exceed this parameter value.
Setting this parameter will prevent the damage caused by accidental
programming error when excute program
Range : 0~1
Unit : None
Authority : Operation admin or super
Default : 0 (program)
Effective time : Instant
Note :
0 - Program home
1 - Mechanical home
Program home is that the coordinates all are zero (actually ,it is the
workpiece home point
Mechanical home :it requires detecting external sensor to locate the home
position; while home operation, move to specified home direction at
home speed, and move back slowly after signal is detected. At this
moment, move forward slowly when the signal is disconnected, and the
home operation completes when the signal is valid again. When the servo
Z phase enable switch in IO configuration parameters is enabled,
mechanical home will enable Z phase positioning as home position
automatically after signal reaches.
Range : 0~8
Unit : None
Authority : Operation admin or super
Default : 0
Effective time : After rebooted
Note :
Set the filter constant;
If the environment has too much interference, e.g. rain and thunder,
please enter a filter value. Higher value indicates longer test time and
high reliability; 0 indicates no filter;