Adtech 4 Series, Руководство по обслуживанию

Страница: 30 / 155

ADTECH 4 series CNC System (maintainance Manual)
26
Emergency stop
:
:
:
:
:
:
:
:
:
When controller shows limit alarm. Please check corresponding limit sensor point or parameters.
If hard limit occurs, and the appearance of the sensor point doesn‘t has any problem, enter the diagnosis
mode and check the state of the input port. If the state is valid, please eliminate in sequence. Disconnect
the input IO cable and check whether the sense disappears. If yes, please check the circuit. If the
problem still exists, the internal optocoupler is broken. Please contact the supplier.
:
Check Emergency stop button of the handheld box is pushed down or not
External emergency stop 2 input is push down?;check whether IO assignment has conflict or
interference.
Search for corresponding function ports in IO configuration, and then check in input diagnosis.
:
:
:
:
Servo alarm; if there is no alarm on servo , parameter P2(axis parameter).001~004 setting and actual
servo alarm level may be reverse. Please modify the parameters.
The corresponding function ports are IN34~37, which can be checked in input diagnosis.
:
axis No. setting by parameter P2.45~P2.49 is specified repeatedly
:
:
:
:
1032
1033
1034
1035
1036
1037
1038
1039
1040
X+ direction program limit
4 - direction machine limit
4 + direction machine limit
Z - direction machine limit
Z + direction machine limit
Y - direction machine limit
Y + direction machine limit
X - direction machine limit
X+ direction machine limit
1041
1042
1043
1044
1045
X Sevor driver alarm
Y Sevor driver alarm
Z Sevor driver alarm
4 Sevor driver alarm
1046 Axis's physical line redefine
1047 spi no to home
1048 workpiece no lock
1049 safe signal can't detect
1051 air no enough