Adtech 4 Series, Руководство по обслуживанию

Страница: 19 / 155

ADTECH 4 series CNC System (maintainance Manual)
15
General instructions for manual operation keys
Cooling, lubricant, spindle cw/ccw are available in MPG, single step and Jog mode;
When the spindle is rotating, press the reverse rotation key, the Spindle will stop first, then rotate to the
reverse direction after pressing it again.
When auxiliary output is on, if the system is switched to other modes, the output is unchanged; you need
to press ―Reset‖ key to switch it off, execute the corresponding M code in automatic mode or execute the
corresponding M code in MDI interface to turn off the output;
When the spindle work cw/ccw and execute M04/M03 directly, the system first stops cw/ccw rotating and
then execute M04/M03 code;
cw/ccw rotating of spindle is stopped while emergency stop pressed, and other outputs can be set
according to system parameters.
4.6 Tool setting
Tool setting is the main operation and important skill for CNC machine operater Under certain conditions,
tool setting precision can determine the precision of parts, and the tool setting efficiency also affects the CNC
processing efficiency directly.there is two ,methods for cnc machine tool setting , i.e. centered and tool setting
gauge
4.6.1 Centered
The centered function is that the system calculates the center position of the workpiece automatically
while tool setting to realize segment centered, rectangle centered and circle center location.
Note
In the tool setting operation below, if the auxiliary parameters of the coordinate system doesn‘t need setting, the first three
steps can be omitted. Please refer to chapter 9.5 for auxiliary parameters of the coordinate system.
⑴
Single axis centered
➢
Select the edit mode;
➢
Select MPG or Jogl mode;
➢
Press [Coord] to enter coordinate system setting interface;
➢
Press the left/right arrow to move the cursor to select coordinate system;
➢
Press [HALVE] to enter centered interface;