Adtech 4 Series, Руководство по обслуживанию

Страница: 147 / 155

ADTECH 4 series CNC System (maintainance Manual)
143
(waiting for disk air cylinder back input
(output blow signa)
(dealy)
(close blow signal)
(output spindle air cylinder push)
(spindle cut loosen input)
install the
chose tool
into spindle
(Z axis move to above the position of tool changing point 2.5mm )
‗s taper suite,
(spindle grab tool)
(z axis move to position of the tool changing point
(spindle tool clamp input)
output air cylinder push signal
tool disc
return
(64)
N7
(65)#2 = #2-1 (ccw reduce 1 each time)
(66)
IF[#2<=0] #2=#400 (if counting NO. is smaller than 0, then recount from
max tool number)
(67)
N8
(68)
END1 (end )
The programs From No (55) to (68) are for counting base on previous tool selection direction to select tool,
principle is accumulation or decrease by current tool number , tool selection is finished when current tool
NO. is same as target tool NO..
(69)
IF[#1==1] GOTO 5 (JUMP to N5)
(70)G04 P#408 (dealy)
(71)M89 P9 L0 close disc cw output signal after delay)
(72)GOTO 6
(73)N5
(74)G04 P#409 (delay)
(75)M89 P10 L0 (close disc ccw output signa after delay)
The programs From (69) to (75) are for closing corresponding port according to previous tool selection
direction.
tool installed to spindle
(76)N6
(77)M89 P11 L1 (output air cylinder push signal)
(78)M88 P6 L0
(79)M89 P13 L1
(80)G04 X#407
(81)M89 P13 L0
(82)M89 P12 L1
(83)M88 P9 L0
(84)G01 Z[#403+2.5] F#405
(85)M89 P12 L0
(86)G01 Z#403 F6000
(87)M88 P10 L0
(88)M89 P11 L0
Finish tool
selcetion