Adtech 4 Series, Руководство по обслуживанию

Страница: 103 / 155

ADTECH 4 series CNC System (maintainance Manual)
99
Spi.Encode bits(p)
014 Spi.Encode bits(p)
023
024
Spi.Encode bits(p)
Spi.Gear Numerator
use servo spindle (servo motor controlled with pulse mode),then you can
set this parameter and set one axis pulse output for spindle pulse port .
Note :if you set one axis pulse port for spinlde pulse prot ,pls change the
one axis pulse port parameter.
For example, set P2.022 X physial Assign Num is 4 ,and 4 physial Assign
Num<
●
> is 1, then, any operation to X axis will be the operation to A
axis pulse port on the shell.
0: no any axis (no pulse output)
1~6: corresponding to 1#---6# axis
Range : 0
～
5000
Unit :
Authority : Operation admin or higher
Default : 2500
Effective time : Instant
Note : This setting is the encoder line of spindle motor
This parameter will affect G74 and G84 tap instructions. Please set it
properly.
Range : 0
～
30000
Unit :
Authority : Operation admin or higher
Default : 24000
Effective time : instant
Note : This setting is used to calculate the analog output of the controller, and
suppose that the analog of variable frequency control is in linear control
mode;
This method is to set the motor speed corresponding to analog 10V, input
the motor rated speed directly, while the controller will output
corresponding analog voltage according to this setting. Only this setting
is right then the controller can output correctly speed value
Spi.Gear : 0
～
65535
021