Adtech 4 Series, Руководство по обслуживанию

Страница: 17 / 155

ADTECH 4 series CNC System (maintainance Manual)
13
4.2 JOG Function
Press the keys on the operation panel or handwheel to move the tool along every axis.
The operation follows:
⑴
Press the mode switch key [Manual] to select manual operation;
⑵
Press composite keys [X+], [X-]; [Y+], [Y-]; [Z+], [Z-]; [A+], [A-] [B+], [B-]; [C+], [C-] in numbers
area to move the tool along selected axis. The keypad follows:
In Jog mode, 5# key can be used to switch the Jog speed and rapid move speed. The rapid move speed of
each axis depends on General parameter 009-012 (fastspeed setting). After switching to rapid move speed, the
Jog speed of the position interface will be highlighted, while the actual speed of the position interface is
sampled from the moving speed of current axis. This value can truly reflect the moving speed of current axis
(unit: mm/min);
Note
Only single axis motion is available at Jog mode.
4.3 Single step
Single step mode is similar to Jog mode, the operations are same, but only moves a specified pulse
increment every time when press the key.
The operation as follows:
⑴
Press the mode switch key [MPG/ step] (this key is composite, and you can press it repeatedly to
switch the modes) to select the single step operation;
⑵
Press composite keys [X+], [X-]; [Y+], [Y-]; [Z+], [Z-]; [A+], [A-] [B+], [B-]; [C+], [C-]in numbers area to
move the tool for a fixed distance via the selected axis. This distance is controlled by four rates (1.000, 0.100,
0.010, 0.001) (unit: mm). To select pulse increment, press Up (+) and Down (-) key in the [Position] interface
4.4 MPG
In MPG mode, rotate the handwheel to make the machine perform single step or continuous motion.
Determine the feed by testing the handwheel signal of the handheld box. In MPG mode, the feeding axis and
feeding unit are determined by the axis selection signal of the handheld box.
The MPG feeding step follows:
⑴
Press the mode switch key [MPG/ step] to select MPG operation;
⑵
Rotate the switch on the handwheel to select axis (X, Y, Z, A,B,C);