ZyXEL Communications Prestige 652, User Manual, Page: 508 / 521

Prestige 652 Series User’s Guide
J-10 Log Descriptions
Chart J-8 Sample IKE Key Exchange Logs
LOG MESSAGE DESCRIPTION
!! Too many errors! Deleting SA The Prestige deletes an SA when too many errors
occur.
!! ID type mismatch The ID type of an incoming packet does not match the
local's peer ID type.
!! ID content mismatch The ID content of an incoming packet does not match
the local's peer ID content.
!! No known phase 1 ID type
found
The ID type of an incoming packet does not match any
known ID type.
vs. My Remote <IP address> The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays this router’s configured remote IP address
type or IP address that the incoming packet did not
match.
vs. My Local <IP address> The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays this router’s configured local IP address type
or IP address that the incoming packet did not match.
-> <symbol> The router sent a payload type of IKE packet.
The following table shows sample log messages during packet transmission.
Chart J-9 Sample IPSec Logs During Packet Transmission
LOG MESSAGE DESCRIPTION
!! WAN IP changed to <IP> If the Prestige’s WAN IP changes, all configured “My IP Addr” are
changed to b “0.0.0.0”. If this field is configured as 0.0.0.0, then the
Prestige will use the current Prestige WAN IP address (static or
dynamic) to set up the VPN tunnel.
!! Cannot find outbound SA
for rule <%d> The packet matches the rule index number (#d), but Phase 1 or
Phase 2 negotiation for outbound (from the VPN initiator) traffic is
not finished yet.