ZyXEL Communications Prestige 652, User Manual, Page: 290 / 521

Prestige 652 Series User’s Guide
25-12 Menu 2 WAN Backup Setup
Table 25-7 Menu 11.3 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
Rem IP
Subnet
Mask Leave this field set to 0.0.0.0 to have the ISP or other remote router
dynamically send its subnet mask if you do not know it. Enter the remote
gateway’s subnet mask here if you know it (static). 0.0.0.0
(default)
My WAN
Addr Leave the field set to 0.0.0.0 to have the ISP or other remote router
dynamically (automatically) assign your WAN IP address if you do not
know it. Enter your WAN IP address here if you know it (static).
This is the address assigned to your local Prestige, not the remote
router.
0.0.0.0
(default)
NAT Press [SPACE BAR] and then [ENTER] to select either Full Feature,
None or SUA Only. See the Network Address Translation (NAT) chapter
for a full discussion on this feature.
None
(default)
Metric Enter a number from 1 to 15 to set this route’s priority among the
Prestige’s routes. The smaller the number, the higher priority the route
has. 15
(default)
Private This parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to
Yes , this route is kept private
and not included in RIP broadcasts. If No , the route to this remote node
will be propagated to other hosts through RIP broadcasts.
No
(default)
RIP
Direction
Press [SPACE BAR] and then [ENTER] to select the RIP direction from
Both/ None / In Only / Out Only and None .
Both
(default)
Version Press [SPACE BAR] and then [ENTER] to select the RIP version from
RIP-1/RIP-2B/RIP-2M.
RIP-1
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (
IGMP-v1 ) and version 2 ( IGMP-v2 ).
Press the [SPACE BAR] to enable IP Multicasting or select None to
disable it. See the LAN Setup chapter for more information on this
feature.
None
(default)
Once you have completed filling in Menu 11.3 Remote Node Network Layer Options , press [ENTER]
at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or press
[ESC] at any time to cancel.