ZyXEL Communications Prestige 652, User Manual, Page: 317 / 521

Prestige 652 Series User’s Guide
Remote Node Configuration 29-7
Table 29-2 Menu 11.3 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
My WAN
Addr Some implementations, especially UNIX derivatives, require separate IP
network numbers for the WAN and LAN links and each end to have a
unique address within the WAN network number. In that case, type the IP
address assigned to the WAN port of your Prestige.
NOTE: Refers to local Prestige address, not the remote router address.
NAT Press [SPACE BAR] and then [ENTER] to select Full Feature if you have
multiple public WAN IP addresses for your Prestige.
SUA Only
Select SUA Only if you have just one public WAN IP address for your
Prestige. The SMT uses Address Mapping Set 255 (menu 15.1 - see
section
32.3.1 ).
Select None to disable NAT.
Address
Mapping Set When Full Feature is selected in the NAT field, configure address
mapping sets in menu 15.1. Select one of the NAT server sets (2-10) in
menu 15.2 (see
the NAT chapter for details) and type that number here.
When SUA Only is selected in the NAT field, the SMT uses NAT server set
1 in menu 15.2 (see the NAT chapter for details).
2
Metric The metric represents the “cost” of transmission for routing purposes. IP
routing uses hop count as the cost measurement, with a minimum of 1 for
directly connected networks. Type a number that approximates the cost for
this link. The number need not be precise, but it must be between 1 and
15. In practice, 2 or 3 is usually a good number. 2
Private This determines if the Prestige will include the route to this remote node in
its RIP broadcasts. If set to
Yes , this route is kept private and not included
in RIP broadcast. If No , the route to this remote node will be propagated to
other hosts through RIP broadcasts.
No
RIP
Direction Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Options are
Both , In Only , Out Only or None .
None
Version Press [SPACE BAR] and then [ENTER] to select the RIP version. Options
are RIP-1 , RIP-2B or RIP-2M .
RIP-1
Multicast IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and
None disables IGMP.
None
IP Policies You can apply up to four IP Policy sets (from 12) by typing in their numbers
separated by commas. Configure the filter sets in menu 25 first (see the
IP
Policy Routing chapter) and then apply them here.
3, 4, 5, 6