Chapter 40 Access Control
GS1920v2 Series User’s Guide
352
The following table describes the labels in this screen.
40.3.3 C o nfig uring SNMP Use r
From the
SNMP
screen, click
Use r
to view the screen as shown. Use the
Use r
screen to create SNMP users
for authentication with managers using SNMP v3 and associate them to SNMP groups. An SNMP user is
an SNMP manager.
Fig ure 256
Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Table 172 Management > Access Control > SNMP > Trap Group > Port
LABEL
DESC RIPTIO N
Option
Select the trap type you want to configure here.
Port
This field displays a port number.
*
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active
Select this check box to enable the trap type of SNMP traps on this port.
Clear this check box to disable the sending of SNMP traps on this port.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
C a nc e l
to begin configuring this screen afresh.
Table 173 Management > Access Control > SNMP > User
LABEL
DESC RIPTIO N
User Information
Note: Use the username and password of the login accounts you specify in this
screen to create accounts on the SNMP v3 manager.
Username
Specify the username of a login account on the Switch.