Chapter 13 Spanning Tree Protocol
GS1920v2 Series User’s Guide
139
The following table describes the labels in this screen.
13.4 C o nfig ure Ra pid Spa nning Tre e Pro to c o l
Use this screen to configure RSTP settings, see
Section 13.1 on page 135
for more information on RSTP.
Click
RSTP
in the
Adva nc e d Applic a tio n
>
Spa nning Tre e Pro to c o l
screen.
Fig ure 108
Advanced Application > Spanning Tree Protocol > RSTP
Table 50 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
DESC RIPTIO N
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select
Ra pid Spa nning Tre e
,
Multiple Ra pid Spa nning Tre e
or
Multiple Spa nning Tre e
. See
Section 13.1 on page 135
for background information on STP.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
C a nc e l
to begin configuring this screen afresh.