GS1920v2 Series User’s Guide
279
30.6 Erro r- Disa b le Re c o ve ry C o nfig ura tio n
Use this screen to configure the Switch to automatically undo an action after the error is gone. Click the
C lic k He re
link
next to
Errdisa b le Re c o ve ry
in the
Adva nc e d Applic a tio n > Errdisa b le
screen to display
the screen as shown.
Fig ure 201
Advanced Application > Errdisable > Errdisable Recovery
The following table describes the labels in this screen.
Mode
Select the action that the Switch takes when the number of control packets exceed the rate
limit on a port, set in the
Adva nc e d Applic a tio n > Errdisa b le > C PU pro te c tio n
screen.
•
ina c tive - po rt
- The Switch disables the port on which the control packets are received.
•
ina c tive - re a so n
- The Switch drops all the specified control packets (such as BPDU) on the
port.
•
ra te - lim ita tio n
- The Switch drops the additional control packets the port(s) has to handle in
every one second.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click
C a nc e l
to begin configuring this screen afresh.
Table 127 Advanced Application > Errdisable > Errdisable Detect (continued)
LABEL
DESC RIPTIO N
Table 128 Advanced Application > Errdisable > Errdisable Recovery
LABEL
DESC RIPTIO N
Active
Select this option to turn on the error-disable recovery function on the Switch.
Reason
This field displays the supported features that allow the Switch to shut down a port or discard
packets on a port according to the feature requirements and what action you configure.
*
Use this row to make the setting the same for all entries. Use this row first and then make
adjustments to each entry if necessary.
Changes in this row are copied to all the entries as soon as you make them.
Timer Status
Select this option to allow the Switch to wait for the specified time interval to activate a port or
allow specific packets on a port, after the error was gone. Deselect this option to turn off this
rule.
Interval
Enter the number of seconds (from 30 to 2592000) for the time interval.
