![background image](http://html1.mh-extra.com/html/zyxel-communications/gs1920-48hpv2/gs1920-48hpv2_user-manual_945073317.webp)
Chapter 35 Static Route
GS1920v2 Series User’s Guide
317
Fig ure 225
IP Application > Static Routing
To enable IPv4 static route, configure the static route settings in the
IP Applic a tio n > Sta tic Ro uting > IPv4
Sta tic Ro ute
screen.
35.3 IPv4 Sta tic Ro ute
Click
IP Applic a tio n
>
Sta tic Ro uting > IPv4 Sta tic Ro ute
in the navigation panel to display the screen as
shown.
Fig ure 226
IP Application > Static Routing > IPv4 Static Route
The following table describes the related labels you use to create a static route.
Table 148 IP Application > Static Routing > IPv4 Static Route
LABEL
DESC RIPTIO N
Active
This field allows you to activate/deactivate this static route.
Name
Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
Destination IP
Address
This parameter specifies the IP network address of the final destination.
IP Subnet Mask
Enter the subnet mask for this destination. Routing is always based on network number. If you
need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the subnet mask
field to force the network number to be identical to the host ID.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that
will forward the packet to the destination. The gateway must be a router on the same segment
as your Switch.