Chapter 33 Link Layer Discovery Protocol (LLDP)
GS1920v2 Series User’s Guide
301
33.6.2 O rg - spe c ific TLV Se tting
Use this screen to configure organization-specific TLV settings. Click
Adva nc e d Applic a tio n
>
LLDP > LLDP
C o nfig ura tio n (C lic k He re ) > O rg - spe c ific TLV Se tting
to display the screen as shown next.
Fig ure 216
Advanced Application > LLDP > LLDP Configuration> Org-specific TLV Setting
The following table describes the labels in this screen.
Management
Address
Select the check box(es) to enable or disable the sending of Management Address TLVs on
the port(s).
Port Description
Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
System Capabilities
Select the check box(es) to enable or to disable the sending of System Capabilities TLVs on
the port(s).
System Description
Select the check box(es) to enable or to disable the sending of System Description TLVs on
the port(s).
System Name
Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
C a nc e l
to begin configuring this screen afresh.
Table 139 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
DESC RIPTIO N
Table 140 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
DESC RIPTIO N
Port
This displays the Switch’s port number.
*
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Dot1 TLV
Port-Protocol
VLAN ID
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs on the port(s).