Yamaha MM700F, Service Manual

Page: 76 / 589

2-21
INSP
ADJ
BRAKE LEVER ADJUSTMENT
(VX700DX/SX700/VT700)
1. Adjust:
•
Brake lever position
(distance from the grip to the brake lever)
Adjustment steps:
•
Loosen the locknut 1 .
•
While lightly pushing the brake lever in direction
a
,
turn the adjusting bolt 2 by fingers to set the brake
lever to the desired position.
•
Tighten the locknut securely after adjusting.
Locknut 1 :
6 Nm (0.6 m · kg, 4.3 ft · lb)
BRAKE FLUID LEVEL INSPECTION
1. Place the machine on a level surface.
2. Check:
•
Fluid level
Fluid level is under the “LOWER” level line
a
→
Fill to the proper level.
Recommended brake fluid:
DOT 4
NOTE:
For a correct reading of the brake fluid level, make
sure that the top of the handlebar brake master
cylinder reservoir is horizontal.
CAUTION:
Brake fluid may corrode painted surfaces or plas-
tic parts. Always clean up spilled fluid immedi-
ately.
WARNING
•
Use only the designated brake fluid. Other
fluids may deteriorate the rubber seals, caus-
ing leakage and poor brake performance.
•
Refill with the same type of fluid. Mixing fluids
may result in a harmful chemical reaction lead-
ing to poor brake performance.
•
When refilling, be careful that water does not
enter the brake master cylinder reservoir. Wa-
ter will significantly lower the boiling point of
the fluid and may cause vapor lock.
BRAKE LEVER ADJUSTMENT (VX700DX/SX700/VT700)/
BRAKE FLUID LEVEL INSPECTION
T
R
.
.
SCH2510
SCH2520