Yamaha FJR1300, Service Manual

Page: 305 / 572

4 - 109
CHAS
SHAFT DRIVE
Therefore, the calculated final drive pinion
gear shim thickness is 0.51 mm (0.02 in). Shim
sizes are supplied in the following thicknesses.
Since the final drive pinion gear shims are only
available in 0.10 mm (0.004 in) increments,
round off to the hundredths digit.
In the example above, the calculated final
drive pinion gear shim thickness is 0.51 mm
(0.02 in). The chart instructs you to round off
the 1 to 0. Thus, you should use a 0.50 mm
(0.02 in) final drive pinion gear shim.
Final drive pinion gear shims
Thickness (mm) 0.30 0.40 0.50
Hundredth Rounded value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10
c. To find ring gear shim thickness “B”, use the
following formula:
Where:
c
= a numeral on the final drive housing, to be
divided by 100 and added to “45”.
d
= a numeral usually on the outside of the
ring gear bearing housing, to be divided by 100
and added to “3”.
e
= a numeral (positive or negative) on the
inside of the ring gear, to be divided by 100
and added to “35.40”.
f
= the ring gear bearing thickness constant.
Ring gear shim thickness
B = (45 +
c
/100) + (3 +
d
/100) –
[(35.40 –
e
/100) +
f
]
Ring gear bearing thickness “
f
”
13.00 mm (0.51 in)