Yamaha FJR1300, Service Manual

Page: 84 / 572

2 - 24
SPEC
TIGHTENING TORQUES
NOTE:
1.First, tighten the lower ring nut approximately 52 Nm (5.2 m • kg, 37 ft • lb) by using the torque
wrench, then loosen the ring nut completely.
2.Retighten the lower ring nut to specification.
Connecting arm and swingarm M10 48 4.8 35
Connecting arm and relay arm M10 48 4.8 35
Rear shock assembly and relay arm M10 40 4.0 29
Rear shock assembly and frame M12 64 6.4 46
Relay arm and frame M10 40 4.0 29
Swingarm pivot shaft and locknut M28 115 11.5 85
Swingarm pivot shaft and pivot shaft nut M18 125 12.5 90
Locknut retainer M6 10 1.0 7.2
Final drive housing oil filler bolt M14 23 2.3 17
Final drive housing oil drain bolt M14 23 2.3 17
Final drive assembly and swingarm M10 42 4.2 30
Left rider footrest bracket and frame M8 28 2.8 20
Left rider footrest bracket and engine M10 49 4.9 35
Left rider footrest bracket, sidestand bracket and
frame
M10 63 6.3 45
Ring gear bearing housing and final drive housing M10 40 4.0 29
Ring gear bearing housing and final drive housing M8 23 2.3 17
Stopper bolt M10 9 0.9 6.5
Gear coupling and final drive pinion gear M16 110 11.0 80
Final drive pinion gear bearing retainer M65 110 11.0 80
Sidestand and sidestand bracket M10 58 5.8 42
Centerstand bracket and frame M10 55 5.5 40
Centerstand and centerstand bracket M10 56 5.6 40
Rear frame and main frame (upper) M8 28 2.8 20
Rear frame and main frame (lower) M10 48 4.8 35
T-bar and frame M10 78 7.8 56
Fuel pump and fuel tank M5 4 0.4 2.9
Battery bracket and frame M6 10 1.0 7.2
Battery holder and battery bracket M6 10 1.0 7.2
Ignition coil M6 10 1.0 7.2
Canister and canister bracket M6 7 0.7 5.1
Canister M6 12 1.2 8.7
Hose holder M6 7 0.7 5.1
Part to be tightened
Thread
size
Tightening torque
Remarks
Nm m·kg ft·lb