98
5
5.3 Common Menu Items
Menu Item
Explanation
Memory Changes
• PCL 6 Memory
Sets the capacity of the memory for the use of PCL 6. When the memory capacity is
increased, the printing speed may be increased, complicated document can be printed,
and a good image quality can be obtained.
The range of setting is between 2.00-16.00 MB with 0.25 MB per unit. Default is 4.50 MB.
• When Menu is pressed after the setting, a system reset will be executed.
"Diagnostics in progress" will be displayed during the system reset and key
operations are not accessible.
• All the data stored in the various memory domains will be cleared by reset.
• The maximum value of the memory capacity that can be set changes
according to the free memory capacity.
• PS Memory*
Sets the capacity of the memory for use by PostScript software. The printing speed may
be increased when the memory capacity is increased.
The range of setting is between 2.00-16.00 MB with 0.25 MB per unit. Default is 4.50 MB.
• When Menu is pressed after the setting, a system reset will be executed.
"Diagnostics in progress" will be displayed during the system reset and key
operations are not accessible.
• All the data stored in the various memory domains will be cleared by reset.
• The maximum value of the memory capacity that can be set changes
according to the free memory capacity.
• Receive Buffer Memory
Sets the memory capacity of the receive buffer for the respective interfaces.
Receive buffer is the temporary storage location of the data sent from the host device.
The memory capacity of the buffer can be changed according to the status and objective
of the usage. Also, the increase of memory capacity for the buffer can speed up the
release of the host device of each interface.
The ranges of settings are as follows:
• For Parallel, Serial, NetWare*, AppleTalk memory*
64 KB - 1024 KB with 32 KB per unit; default: 64 KB (NetWare default: 224 KB)
• For lpd/PD Spool*
Hard Disk: 64 KB - 1024 KB with 32 KB per unit
Memory: 0.50 MB - 32.00 MB with 0.25 MB per unit; default: 1 MB
None: 64 KB - 1024 KB with 32 KB per unit; default: 224 KB
• When Menu is pressed after the setting, a system reset will be executed.
"Please wait" will be displayed during the system reset and key operations
are not accessible.
• In the following cases, items will not be displayed:
When the interface card is not installed
"lpd", "NetWare" will not be displayed when the interface card (for
Ethernet 10BASE-5) is not installed.
When Port Status is set to OFF
When Port Status is set to OFF, the corresponding item will not be
displayed.
• Depending on the data volume sent from the host device, the releasing time
for the host device may not be changed even if the memory capacity is
increased.
* Optional
Summary of Contents for Document Centre 400 series
