Xerox Document Centre 400 series, User Manual

Page: 111 / 185

99
Mode Menu/Common Menu
5
5.3 Common Menu Items
Menu Item Explanation
Memory Changes • Receive Buffer Memory (For lpd/PD Spool)
• After removing the additional RAM module and switching on the power, the
following process will be executed automatically if memory becomes
insufficient compared with the previous memory setting:
(1) Change and allocate the setting values of the various memories (e.g.
Receive buffer memory).
(2) If allocation in (1) is not possible, stop the status of port related to
Ethernet and reallocate.
To increase the memory capacity of the receive buffer, either stop the status
of port not in use or install the additional RAM module.
Port Status Sets the state of the various ports when the power is switched on.
• Parallel
Sets to activate/inactivate the parallel port when the power is on.
The candidate values are as follows:
• Enabled (Default)
Activates the parallel port when the power is on.
• Disabled
Inactivates the parallel port when the power is on.
• Serial
Sets to activate/inactivate the serial port when the power is on.
The candidate values are as follows:
• Enabled
Activates the serial port when the power is on.
• Disabled (Default)
Inactivates the serial port when the power is on.
• lpd/PD*
Sets to activate/inactivate the lpd/PD port when the power is on.
The candidate values are as follows:
• Enabled
Activates the port in use by lpd/PD when the power is on.
• Disabled (Default)
Inactivates the port in use by lpd/PD when the power is on. If transport is not set, it
will automatically move to the transport setting menu when Disabled is selected.
This item is displayed when the interface card (for Ethernet 100BASE TX/5) is installed.
• NetWare*
Sets to activate/inactivate the NetWare port when the power is on.
The candidate values are as follows:
• Enabled
Activates the port in use by NetWare when the power is on.
• Disabled (Default)
Inactivates the port in use by NetWare when the power is on.
This item is displayed when the interface card (for Ethernet 100BASE TX/5) is installed.
* Optional
(con’t...)