Xerox 4213, User Manual

Page: 354 / 441

XEROX COAX/TWINAX OPTION
Table A3-3. IBM Error Codes (continued
Number Message Meaning/action
1419 XES formatting error An inconsistency has occurred in translating the data stream
into XES. This may result in loss of text and/or change in
appearance of presented information.
1420 Initialisation error An inconsistency has occurred during initialisation. Results
of subsequent operations may be unreliable.
1421 Software error A software inconsistency has been detected. Results of
subsequent operations may be unreliable.
1422 Set up parser error An invalid set up command has been detected in the host
data stream.
1423 Protocol error An inconsistency has been detected at the protocol level.
1424 Non-volatile RAM error An invalid checksum was detected in the non-volatile
memory. All settings have been reset to factory defaults.
1425 Multiple errors occurred. Some error reports have been lost.
1511 Power up diagnostic tests
indicate a fault with the Co-
Ax/Twin-Ax interface. Power off. Check that the PWB and the cartridge are
installed correctly. Then, power back on. If fault continues
to occur, replace the PWB and cartridge.
XEROX 4213 LASER PRINTER USER GUIDE A3-83