WTI PollCat NetLink, User Manual, Page: 95 / 256

10. Pager ID 1: The first default Pager ID number. When
alphanumeric pager notification is selected, this is the first
pager I.D. number dialed when an Alarm is triggered.
NetLink can dial up to three pagers for each clue.
11. Pager ID 2: The second default Pager ID Number.
12. Pager ID 3: The third default Pager ID Number.
13. SNMP Management: Selects the default SNMP Manager,
that will receive SNMP Traps generated by Alarm Clues.
This item selects one, both or none of the two SNMP
Managers. IP Addresses for SNMP Managers are defined
via the Network Port Configuration Menu as described in
Section 4.4.5.
14. Output Contacts: Defines the default open/close action
that will be performed by the optional Output Contacts
when an Output Contact action is generated. A "C"
indicates the contact will be closed, "O" indicates the
contact will be opened, and a dash (-) indicates that the
status of the contact will not be changed.
15. Message: Defines the default message that will be sent
when the alarm action is Alphanumeric Page, Numeric
Page, SNMP Trap or Console.
16. Auto Execute: Sets the default state for the Auto Execute
feature. When enabled, NetLink will execute the command
string defined under item 17 when a Callout or Console
action is generated.
17. Execute Commands: Defines the default Auto Execute
command string. This command string will be invoked
when Auto Execute is enabled, and a Callout or Console
Action is generated. The command string consists of a
series of ^Bxx commands. The ^Bxx commands are listed
in the Command Help Screen (Main Menu, item 5), and are
discussed further in Section 18.
Example: To automatically send the Site ID Message and
then send all alarm records, the Auto Execute Command
String would be defined as " 03/01,ALM ". Note that the
^B character is not included in the command string, and that
each command is separated by a slash character ( / ).
8-5
The Alarm Filters (Toll Fraud Detection)